![]() ![]() It has conically shaped rollers on spindles and bearings set at an angle to the axis of the bit. The three roller Tricone bit is the most common roller bit. If possible, use roller bits for reaming the 10 cm pilot hole open to 15 cm because they produce minimal amounts of clay smearing etc on borehole walls. Roller bits exert a crushing and chipping action, making it possible to cut hard rock formations (Driscoll, 1986). The cutting surfaces of all roller bits are flushed by jets of drilling fluid directed from the inside (centre) of the bit. The teeth of adjacent cones intermesh so that self-cleaning occurs. They are designed so that each tooth applies pressure at a different point on the bottom of the hole as the cones rotate. Roller bits have three or more cones ("rollers" or "cutters") made with hardened steel teeth or tungsten carbide inserts of varied shape, length and spacing. Possible, drag bits should be used to drill pilot holes because they produce cuttings which are easiest to log. However, it does not work well in coarse gravel or hard-rock formations. Most drilling is done using the Drag bit (especially in clay and sands). Drag bits have a shearing action and cut rapidly in sands, clays and some soft rock formations. A blade bit is a drag bit in which the blades can be replaced. Short nozzles direct jets of drilling fluid down the faces of the blades to clean and cool them (Driscoll, 1986). Three general types of bits are used when drilling with the LS-100: the drag (blade or fishtail) bit, the roller (or tricone) bit and reamer bits (see Figure 7).ĭrag bits have short blades, each forged to a cutting edge and faced with tungsten carbide tips. A 15 cm bit can be used without first drilling a pilot hole where drilling is easy, the water table close to surface or subsurface conditions are well known. In overburden and soft rock formations, 15 cm bits are used to ream the pilot hole open wider so that the casing ( Section 7), filter pack ( Section 8), and grout annual seal ( Section 9) can be placed. Given the limited power of the LS-100, wells are commonly extended into rock using a 10 cm hole which is left uncased (a 15 cm hole should be drilled several feet into the rock to firmly seat the surficial casing). Maximizes drilling speed and gives the drilling crew a "preview" of subsurface conditions. Usually a 10 cm drill bit is used to drill a pilot hole (especially in hard formations). When drilling with the LS-100, there are two basic sizes of drill bits: 10 cm (4 in) and 15 cm (6 in).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |